Cisco Systems IWIRELESS-G WRT54G2 Manuel d'utilisateur télécharger pdf (Page 5)

Chapter 1

Product Overview

Wireless-G Broadband Router

Chapter 1:

Product Overview

Thank you for choosing the Linksys by Cisco Wireless-G

Broadband Router. The Router lets you access the Internet

via a wireless connection, broadcast at up to 54 Mbps, or

through one of its four switched ports. You can also use

the Router to share resources such as computers, printers

and files.

A variety of security features help to protect your data and

your privacy while online. Security features include WPA2

security, a Stateful Packet Inspection (SPI) firewall and

NAT technology. Configuring the Router is easy using the

provided browser-based utility.

Front Panel

1, 2, 3, 4 (Green) These numbered LEDs,

corresponding with the numbered ports on the

Router’s back panel, serve two purposes. If the

LED is continuously lit, the Router is successfully

connected to a device through that port. A

flashing LED indicates network activity over

that port.

Wi-Fi Protected Setup Button If you have

client devices, such as wireless adapters, that

support Wi-Fi Protected Setup, then you can

use Wi-Fi Protected Setup to automatically

configure wireless security for your wireless

network(s).

To use Wi-Fi Protected Setup, run the Setup

Wizard, or refer to Wi-Fi Protected Setup, page

10.

Wi-Fi Protected Setup LED (Green/

Amber) It lights up green when wireless

security is enabled. The LED flashes green for

two minutes during Wi-Fi Protected Setup.

The LED lights up amber if there is an error

during the Wi-Fi Protected Setup process. Make

sure the client device supports Wi-Fi Protected

Setup. Wait until the LED is off, and then try again.

The LED flashes amber when a Wi-Fi Protected

Setup session is active, and a second session

begins. The Router supports one session at a

time. Wait until the LED is off before starting the

next Wi-Fi Protected Setup session.

Wireless (Green) The Wireless LED lights up

when the wireless feature is enabled. If the LED

is flashing, the Router is actively sending or

receiving data over the network.

Internet (Green) The Internet LED lights up

when there is a connection made through the

Internet port. A flashing LED indicates network

activity over the Internet port.

Power (Green) The Power LED lights up

and will stay on while the Router is powered

on. When the Router goes through its self-

diagnostic mode during every boot-up, this

LED will flash. When the diagnostic is complete,

the LED will be solidly lit.

Back Panel

Internet The Internet port is where you

connect your cable or DSL Internet connection.

1, 2, 3, 4 These Ethernet ports (1, 2, 3, 4) connect

the Router to PCs on your wired network and

other Ethernet network devices.

Reset There are two ways to reset the Router’s

factory defaults. Either press and hold the Reset

Button for approximately five seconds, or restore

the defaults from Administration > Factory

Defaults in the Router’s web-based utility.

Power The Power port is where you connect

the power adapter.

Placement Options

There are two ways to physically install the Router. The

first way is to place the Router horizontally on a surface.

The second way is to mount the Router on a wall.

Horizontal Placement

The Router has four rubber feet on its bottom panel. Place

the Router on a level surface near an electrical outlet.

1 2 3 4 5 6 7 8 9 10 ... 155 156

Commentaires sur ces manuels

Pas de commentaire

Cisco Systems IWIRELESS-G WRT54G2 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Cisco Systems IWIRELESS-G WRT54G2