search

Cisco Systems ASR1000 Manuel d'utilisateur Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 22
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
3-3
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-01
Chapter 3 Preparing Your Site for Installation
Standard Warning Statements
Note The English warnings in this document are followed by a statement number. To see the translations of a
warning into other languages, look up its statement number in the Regulatory, Compliance, and Safety
Information for the Cisco Aggregation Services Router 1000 Series document.
Standard Warning Statements
This section describes the warning definition and then lists core safety warnings grouped by topic.
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Note: SAVE THESE INSTRUCTIONS
Statement 1071
General Safety Warnings
Warning
Read the installation instructions before you connect the system to its power source.
Statement 1004
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
No user-serviceable parts inside Do not open.
Statement 1040
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Table 1 Compliance Requirements
Safety Compliance and NEBS Requirements
Specification Description
Safety
To comply with the Telecom port Conducted emissions requirements of EN55022:1998 and
CISPR22:2003- shielded-twisted pair cables must be used with the 8-port channelized
T1/E1 SPA interface. EN55022: Revisions 73-8358-05 through 73-8358-08
NEBS
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility
and safety, for Ethernet RJ-45 ports, use only shielded Ethernet cables that are grounded
on both ends. In a NEBS installation, all Ethernet ports are limited to intrabuilding wiring.
Vue de la page 2
1 2 3 4 5 6 7 8 ... 21 22

Commentaires sur ces manuels

Pas de commentaire
  • Voltec Aquajet-inc Shanghai Qianjin Electronic Equipment Synkro Digital Box
  • BeefEater Barbecues et grillades Land Pride Outils de jardin ICY BOX Cartes de réseautage Emerson Protecteurs de surtension Furuno Mise en réseau
  • Philips CD1901B DigiDesign D-Control Brother TN 430 Sony MHC-EX600 Seiko 6A32
  • Dell Vostro 500 Manuel de l'utilisateur Pioneer XW-SMA3-W Manuel de l'utilisateur Countax Garden Tractor Instructions d'exploitation Philips SHB7250/27 Manuel de l'utilisateur