Cisco Systems MDS 9216 Guide de l'utilisateur télécharger pdf (Page 6)

Send documentation comments to [email protected].

Chapter 3 Connecting the Cisco MDS 9216 Switch

Connecting to the MGMT 10/100 Ethernet Port

3-6

Cisco MDS 9216 Switch Hardware Installation Guide

78-16165-01

The default COM1 settings are as follows:

line Aux:

Speed: 9600 bauds

Databits: 8 bits per byte

Stopbits: 1 bit(s)

Parity: none

Modem In: Enable

Modem Init-String -

default : ATE0Q1&D2&C1S0=1\015

Statistics: tx:17 rx:0 Register Bits:RTS|DTR

Connecting to the MGMT 10/100 Ethernet Port

Caution To prevent an IP address conflict, do not connect the MGMT 10/100 Ethernet port

to the network until the initial configuration is complete. For configuration

instructions, refer to the Cisco MDS 9000 Family Configuration Guide.

The MGMT 10/100 Ethernet port (labeled MGMT 10/100) is autosensing and has

an RJ-45 interface (Figure 3-3 on page 3-7). You can use this port to access and

manage the switch by IP address, such as through Fabric Manager.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Cisco Systems MDS 9216 Guide de l'utilisateur Page 6