Cisco Systems 4/8xFE Guide de l'utilisateur télécharger pdf (Page 42)

Chapter 4 Installation and Maintenance

Installing the SCE 2000 Platform

Cisco SCE 2000 4/8xFE Installation and Configuration Guide

4-6 OL-7826-05

Step 4 Attach the rubber feet by removing the adhesive strips and affix the rubber feet onto the marked

locations (on the bottom panel).

Step 5 Replace the SCE 2000 platform firmly on the tabletop or workbench.

Remember to check for proper ventilation. Allow at least 2 inches (5 cm) on each side for proper

ventilation and 5 inches (12.7 cm) at the back for ventilation.and power cord clearance.

This completes the general workbench or tabletop installation.

Proceed to section, Attaching a Chassis Ground Connection (on page 4-10) to continue the

installation.

Rack-Mounting a SCE 2000 Platform

You can mount the SCE 2000 platform to a 19” rack. There are two standard types of equipment

racks, and the appropriate brackets for each are provided in the enclosed kit.

• 19” rack with front rack posts — the mounting kit includes two mounting brackets as

illustrated below.

• 19” rack with front and back rack posts — in addition to the mounting brackets illustrated

below, the mounting kit includes two crossrail supports that the unit slides onto.

Mounting Brackets for 2-post Rack Mounting Brackets for 4-post Rack

The SCE 2000 mounts to the two front rack posts with brackets that attach to the front of the SCE

2000 The inside width between the two posts or mounting strips (left and right) must be at least

17.3 inches (44 cm).

Note

Remember to leave a two-inch (5 cm) clearance on both sides of the SCE 2000 and at the rear for

adequate airflow for the inlet and exhaust vents.

Because the inlet and exhaust ports (vents) for cooling air are located at both sides of the chassis,

respectively, multiple SCE 2000s can be stacked in a rack with no vertical clearance.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 130 131

Pas de commentaire

Cisco Systems 4/8xFE Guide de l'utilisateur Page 42