Cisco Systems MCU24 Manuel d'utilisateur télécharger pdf (Page 26)

2-4

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1

OL-11897-01

Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU

Mounting the Cisco Unified Videoconferencing 3515 MCU Unit in a 19-inch Rack

Mounting the Cisco Unified Videoconferencing 3515 MCU Unit

in a 19-inch Rack

You can optionally mount the Cisco Unified Videoconferencing 3515 MCU unit in a standard 19-inch

rack. Two mounting brackets and a set of screws are included in the Cisco Unified

Videoconferencing 3515 MCU unit shipping box.

Procedure

Step 1 Disconnect all cables including the power cables.

Step 2 Place the Cisco Unified Videoconferencing 3515 MCU unit right-side up on a hard flat surface, with the

front panel facing you.

Step 3 Position a mounting bracket over the mounting holes on each side of the Cisco Unified

Videoconferencing 3515 MCU unit, as shown in Figure 2-2.

Figure 2-2 Fitting a Bracket for Rack Mounting

Step 4

Pass the screws through the brackets and tighten them into the screw holes on each side of the

Cisco Unified Videoconferencing 3515 MCU unit using a suitable screwdriver.

Step 5 Insert the Cisco Unified Videoconferencing 3515 MCU unit into the 19-inch rack.

Step 6 Fasten the brackets to the side rails of the rack.

Step 7 Make sure that the air vents at the sides of the Cisco Unified Videoconferencing 3515 MCU unit are not

blocked.

157263

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 53 54

Pas de commentaire

Cisco Systems MCU24 Manuel d'utilisateur Page 26