Cisco Systems Network Cabling Manuel d'utilisateur télécharger pdf (Page 9)

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE 24

Changing Switch Number 3 to Switch Number 2 New Switch Number

will be effective after next reboot

6. Exit the configuration mode, as follows:

7. Halt and perform a cold restart, as follows:

00:08:23: %SYS-5-RELOAD: Reload requested

Base ethernet MAC Address: 00:11:bb:7e:94:80

Xmodem file system is available.

The password-recovery mechanism is enabled.

Initializing Flash...

flashfs[0]: 79 files, 4 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 15998976

flashfs[0]: Bytes used: 6457856

flashfs[0]: Bytes available: 9541120

flashfs[0]: flashfs fsck took 8 seconds.

...done Initializing Flash.

Boot Sector Filesystem (bs) installed, fsid: 3

done.

...

Press RETURN to get started!

Proceed to step 1 in Setting switch options on page 24 to continue the switch configuration

procedure.

Setting switch options

This procedure provides the minimal configuration required to support the reference system.

Configure the first switch stack as follows:

1. Select the

Enter

key to get started. Skip the initial configuration, as follows:

At this prompt... Enter... Notes

sw01# exit

At this prompt... Enter... Notes

sw01> reload

System configuration has been modified.

Save? [yes/no]:

Proceed with reload? [confirm] y

Displays the following output:

At this prompt... Enter... Notes

--- System Configuration Dialog ---

would you like to enter the initial configuration

dialog? [yes/no]:

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

Cisco Systems Network Cabling Manuel d'utilisateur Page 9