Cisco Systems RF Gateway 10 Guide de démarrage rapide télécharger pdf (Page 19)

4 Connecting Cables

This section describes how to do the cabling in the Cisco RFGW-10 UEQAM.

Power and Ground Connections

Each DC PEM has an earth ground connection and two DC power input connections (Input 1 and Input 2). Both external DC

inputs must be connected as shown in

Figure 13. Input 1 and Input 2 are individual power inputs. Both power inputs on the

PEM must be wired to external power for the Cisco RFGW-10 to operate properly. If both inputs are not connected to external

power, the Cisco RFGW-10 will not power on.

Caution The exposed portions of the power lugs must be covered with heat shrink tubing prior to installation.

Figure 13 DC PEM Faceplate

Connect the Console and Management Ports

Each Supervisor card has an Ethernet console and a 10/100 management port for connection to a console.

Note To meet FCC requirements, Ferrite clamps are recommended for both the console and the auxiliary cables for the

supervisor cards. The ferrites should be placed as close as possible to the RJ-45 connectors on the supervisor card. These

ferrites are included in the accessory kit.

Console Port

The console port provides local administrative access to the router and its command-line interface (CLI).

273170

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Pas de commentaire

Cisco Systems RF Gateway 10 Guide de démarrage rapide Page 19