Cisco Systems PAP2 Guide de dépannage télécharger pdf (Page 14)

Phone Adapter with 2 Ports for Voice-over-IP

Chapter 3: Connecting the Phone Adapter

Placement Options

Wall-Mount Option

The Phone Adapter has two wall-mount slots on its back panel. The distance between the two slots is 58 mm

(2.28 inches).

1. Determine where you want to mount the Phone Adapter.

2. Drill two holes into the wall. Make sure the holes are 58 mm (2.28 inches) apart.

3. Insert a screw into each hole, and leave 5 mm (0.2 inches) of its head exposed.

4. Maneuver the Phone Adapter so the wall-mount slots line up with the two screws.

5. Place the wall-mount slots over the screws and slide the Phone Adapter down until the screws fit snugly into

the wall-mount slots.

Congratulations! The installation of the Phone Adapter is complete.

If you need to change any of the Phone Adapter’s network settings, proceed to “Chapter 4: Using the

Phone Adapter’s Interactive Voice Response Menu.”

Figure 3-7: Measurement between

Wall-Mount Slots

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 45 46

Pas de commentaire

Cisco Systems PAP2 Guide de dépannage Page 14