Cisco Systems UCS C210 Manuel d'utilisateur télécharger pdf (Page 97)

C-3

Cisco UCS C210 Server Installation and Service Guide

OL-20887-02

Appendix

Enabling the Mezzanine Card RAID Controller in the BIOS

When using the supported mezzanine-style RAID controller cards, you must enable the ICH10R

controller in Enhanced mode.

Step 1 Make sure that a RAID cable is attached between the mezzanine card and the disk backplane.

Step 2 Boot the server and press F2 when prompted to enter the BIOS Setup utility.

Step 3 Select the Advanced tab, then Mass Storage Controllers Configuration.

Step 4 Set Onboard SATA Controller to Enabled.

Step 5 Set SATA Mode to Enhanced.

Step 6 Press F10 to save your changes and exit the utility.

Step 7 To set up a RAID configuration when using the mezzanine card, boot the server and press Ctrl-C when

prompted to start the WebBIOS utility.

RAID Controller Cabling

The RAID controller connectors in this server are shown in Figure C-1. The blue line indicates the

recommended cable routing path from the backplane to the possible controller locations.

Figure C-1 RAID Controller Connectors

1 Extender or expander backplane 3 Mezzanine card connector

2 Integrated RAID connector on

motherboard

4 LSI MegaRAID PCIe card connectors

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 103 104

Pas de commentaire

Cisco Systems UCS C210 Manuel d'utilisateur Page 97