Cisco Systems H.323/SIP Guide de l'utilisateur télécharger pdf (Page 33)

3-7

Administrator Guide for Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1

OL-6571-02

Chapter 3 Configuring Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1

Information About Configuring Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1 for Use With

Information About Configuring Cisco Unified MeetingPlace

H.323/SIP IP Gateway Software Release 5.2.1 for Use With

Cisco Unified MeetingPlace Web Conferencing

You can install Release 5.2.1 on either the same or separate server as Cisco Unified MeetingPlace

Web Conferencing. If you install Release 5.2.1and Cisco Unified MeetingPlace Web Conferencing on

the same server, you must configure the server to include a primary and secondary IP address. Release

5.2.1 uses the primary address, and you must configure Cisco Unified MeetingPlace Web Conferencing

to use the secondary address. If Release 5.2.1 is installed on a server with more than one IP address, you

must define a gateway for each IP address either in Cisco Unified CallManager, Cisco SIP Proxy server,

or H.323 Gatekeeper for outdials to work.

Note Before you install multiple Cisco Unified MeetingPlace system integration applications on the same

server, ensure that your system meets the requirements for integration. For additional information, see

Important Information About Cisco Unified MeetingPlace Products and Cisco Media Convergence

Servers at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/conf/mtgplace/mpmcs.htm

How to Configure Cisco Unified MeetingPlace H.323/SIP IP

Gateway Software Release 5.2.1 for Use With Cisco Unified

MeetingPlace Web Conferencing

To configure Release 5.2.1 for use with Cisco Unified MeetingPlace Web Conferencing, perform the

following procedure:

Assigning the Primary IP Address

Step 1 From the IP-gateway server desktop, right-click Network Neighborhood and choose Properties.

Step 2 In the Protocols tab, click TCP/IP Protocol and click Properties.

Step 3 In the TCP/IP Properties window, select the IP Address tab.

Step 4 Enter your system information into the corresponding fields shown in Table 3-5.

Table 3-5 IP Address Tab Fields

Field Task

Adapter Choose the adapter that allows MeetingPlace IP Gateway to

communicate with the network.

Radio buttons Choose Specify an IP address.

IP Address Enter the primary address for the IP-gateway server

Subnet Mask Enter the subnet mask for the IP-gateway server.

Default Gateway Enter the default gateway for the IP-gateway server.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Pas de commentaire

Cisco Systems H.323/SIP Guide de l'utilisateur Page 33