Cisco Systems SFS 3012R Manuel d'installation télécharger pdf (Page 46)

3-2

Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide

OL-11187-01

Chapter 3 Installing and Removing Server Switch Field Replaceable Units (FRUs)

Installing a Controller Module

To install a controller module, perform the following steps:

Step 1 Ground yourself with an approved ground wrist strap.

Step 2 Remove the blanking panel if one resides in the slot.

Step 3 Remove the controller module from any packaging.

Step 4 Extend the ejector lever on the module completely.

Step 5 Insert the controller module into slot 1 (left-most) or slot 14 (right-most) so that the ejector lever sits on

the bottom-left-hand side of the module, as shown in Figure 3-1.

Step 6 Push the controller module firmly into the slot. The ejector lever begins to close.

Figure 3-1 Inserting the Controller Module

180742

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 83 84

Pas de commentaire

Cisco Systems SFS 3012R Manuel d'installation Page 46