Cisco Systems Modular Gigabit Ethernet Line Card I Guide de l'utilisateur télécharger pdf

Corporate Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

InsertinganEPAintoaModularGigabitEthernet

Line Card

December 16, 2005

Document Part Number: 78-17296-01 A0

To insert an EPA into the Modular Gigabit Ethernet line card, follow these steps:

Warning

You must use an ESD-preventive wrist or ankle strap to do this procedure. Attach an ESD-preventive

wrist or ankle strap and follow its directions for use, before you do this procedure.

Step 1 First, read the yellow caution label on the EPA. Figure 1 shows a sample of this caution label.

Figure 1 Locations of Labels and Reference Points on the EPA

Caution The connectors must be engaged without any angular misalignment. Engaging the connectors at an angle

will cause damage to the connectors.

149341

ATTENTION:

USE CARE DURING INSTALLATION OF EPA CARD,

MIS-ALIGNMENT CAN CAUSE DAMAGE TO THE

CONNECTOR AT THE UNDERSIDE REAR OF THE PCB.

MAKE SURE THAT THE CONNECTOR IS FULLY

ENGAGED BY PUSHING DOWN ON THE 2X LABELS

BEFORE INSTALLATION OF FRONT PANEL SCREWS (2X).

DO NOT APPLY EXCESSIVE FORCE TO THE FRONT

PANEL OR TOP SURFACE DURING INSTALLATION OR

DAMAGE CAN OCCUR TO THE PCB CONNECTOR.

1 2 3 4 5 6 7

Line Card 1
78-17296-01 A0 2

Résumé du contenu

Page 1 - Line Card

Page 2 - 78-17296-01 A0

2Inserting an EPA into a Modular Gigabit Ethernet Line Card78-17296-01 A0Step 2 Ensure that the connector guide pins are aligned, and mate the connect

Page 3

3Inserting an EPA into a Modular Gigabit Ethernet Line Card78-17296-01 A0Step 3 Ensure that the connector guide pins are aligned. Once the connector i

Page 4

4Inserting an EPA into a Modular Gigabit Ethernet Line Card78-17296-01 A0Step 4 Press gently on the white labels in middle of the outer edge of the EP

Page 5

5Inserting an EPA into a Modular Gigabit Ethernet Line Card78-17296-01 A0Step 5 Use a Phillips screwdriver to insert and tighten the screw on the EPA,

Page 6

6Inserting an EPA into a Modular Gigabit Ethernet Line Card78-17296-01 A0Step 6 Use a Phillips screwdriver to insert and tighten the two screws on the

Page 7

7Inserting an EPA into a Modular Gigabit Ethernet Line Card78-17296-01 A0CCSP, CCVP, the Cisco Square Bridge logo, Follow Me Browsing, and StackWise a