CHAPTER
11-1
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
OL-4387-02
11
Miscellaneous SSG Features
This chapter describes the following SSG features:
• VPI/VCI Static Binding to a Service Profile, page 11-1
• RADIUS Virtual Circuit Logging, page 11-2
• AAA Server Group Support for Proxy Services, page 11-2
• Packet Filtering, page 11-3
• SSG Unconfig, page 11-5
• SSG Enhancements for Overlapping Services, page 11-7
VPI/VCI Static Binding to a Service Profile
The VPI/VCI Static Binding to a Service Profile feature allows users accessing SSG through a VPI/VCI
or a range of VPI/VCIs to access the server. When a user session arrives on a VPI/VCI or a VPI/VCI
range and the session specifies the username but does not specify the domain name, SSG maps the user
session to the service to which the VPI/VCI or VPI/VCI range is bound.
For more information, refer to the”Configuring VPI/VCI Indexing to Service Profile” section in the
Node Route Processor—Service Selection Gateway Enhancements, Release 12.0(5)DC feature module.
Restrictions for VPI/VCI Static Binding to a Service Profile
The VPI/VCI Static Binding to a Service Profile feature has the following restrictions:
• The feature applies only to PPP sessions.
• You must statically configure the feature.
• SESM cannot map the VC to the service.
Configuration of VPI/VCI Static Binding to a Service Profile
To map a VC to a service, use the ssg vc-service-map command in global configuration mode. For more
information, refer to the ”Broadband Access: Service Selection Gateway Commands” section in the
Cisco IOS Wide-Area Networking Command Reference, Release 12.2T.
Commentaires sur ces manuels