Cisco Systems OL-15491-01 Manuel d'utilisateur télécharger pdf (Page 83)

A-83

Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide

OL-15491-01

Appendix A CSG2 Command Reference

ip csg mode single-tp

To enable the CSG2 to use a single traffic processor (TP) instead of multiple TPs, use the ip csg mode

single-tp command in global configuration mode. To restore the default setting, use the no form of this

command.

ip csg mode single-tp

no ip csg mode single-tp

Syntax Description This command has no arguments or keywords.

Defaults The CSG2 operates in multiple-TP mode.

Command Modes Global configuration

Command History

Usage Guidelines In normal multiple-TP mode, the CSG2 distributes subscriber traffic among all of the TPs, based on each

subscriber’s IP address. In single-TP mode, the CSG2 dispatches traffic for all subscribers to the first TP

to be processed.

Single-TP mode is required for HTTP X-Forwarded-For operation. Before configuring the CSG2 for

X-Forwarded-For operation, configure the CSG2 for single-TP mode by entering the ip csg mode

single-tp command, then performing a write memory, then restarting the CSG2.

To switch out of single-TP mode, enter the no ip csg mode single-tp command, then perform a write

memory, then restart the CSG2.

If you intend to operate in single-TP mode, the ip csg mode single-tp command must be the first

command in your CSG2 configuration.

Examples The following example shows how to configure single-TP mode for the CSG2:

ip csg mode single-tp

Related Commands

Release Modification

12.4(11)MD This command was introduced.

Command Description

subscriber-ip http-header forwarded-for Specifies that the CSG2 is to obtain the subscriber's

IP address from the HTTP X-Forwarded-For header.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 255 256

Pas de commentaire

Cisco Systems OL-15491-01 Manuel d'utilisateur Page 83