Cisco Systems NSS2000 Series Guide de démarrage rapide télécharger pdf (Page 10)

Setting up the Hardware

Step 2 — Install the Ethernet Link

NSS2000 Getting Started Guide 6

Step 2 — Install the Ethernet Link

After the disk drives are installed in the chassis, you are ready to connect the

Ethernet cable.

To connect the Ethernet cable to the NSS:

STEP 1 Install the Ethernet cable to the Ethernet port at the back of the NSS chassis.

STEP 2 Connect the Ethernet cable to your network.

Make sure all the connections are secure. You are now ready to continue with

Step 3 — Install the Power.

NOTE: If you are hotplugging an Ethernet

cable to the NSS after the initial installation,

ensure you wait 15 seconds between the time

you unplug the cable and plug it back in. Within

10 seconds the newly connected link should

appear with the correct IP and link rate in the

configuration interface.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Pas de commentaire

Cisco Systems NSS2000 Series Guide de démarrage rapide Page 10