Cisco Systems 4xGBE Guide de l'utilisateur télécharger pdf (Page 45)

Chapter 4 Installation and Maintenance

Installing the SCE 2000 Platform

SCE 2000 4xGBE Installation and Configuration Guide

OL-7824-02 4-9

Figure 4-5: Attaching the Mounting Brackets (2-post)

Step 3

Repeat steps 1 and 2 on the other side of the SCE 2000.

This completes the steps for attaching the rack-mount brackets to the SCE 2000.

If mounting the SCE 2000 in a rack with only two posts, skip to Mounting the System to a Rack (Mounting

the System to a Rack "Mounting the System to the Rack" on page 4-11).

If mounting the SCE 2000 in a rack with four posts, proceed to the next step to attach the crossrail supports

to the rack.

Attaching the Crossrail Supports to the Rack

When mounting in a rack with four posts (front and back) the two crossrail supports are mounted

one on each side of the rack. The SCE 2000 then slides into these crossrails, which support the

weight of the unit.

Note

Cisco recommends that you allow at least 1 or 2 inches (2.54 or 5.08 cm) of vertical clearance between

the SCE 2000 and any equipment directly above and below it.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 151 152

Pas de commentaire

Cisco Systems 4xGBE Guide de l'utilisateur Page 45