Cisco Systems SFS 7000P Manuel d'installation télécharger pdf (Page 52)

Chapter 3 Installing Field Replaceable Units

Removing Power Supplies and Fan Units

3-5

Cisco SFS 7000P Hardware Installation Guide

OL-9167-01 Rev. A0

Figure 3-3 Power Supply LEDs

Removing Power Supplies and Fan Units

Caution Do not remove the power supply or fan unit without first removing the screws. Use

a Phillips screw driver.

Step 1 Make sure you have a number 1 Phillips screwdriver to disengage the fasteners.

Step 2 Ground yourself appropriately.

Caution Never place your hand inside an empty card or module bay or anywhere inside the

Cisco SFS 7000P switch.

Step 3 Locate the power or fan unit that you want to remove.

If you have two power or fan units installed, you can remove one of them without

removing power from the switch.

Step 4 Unscrew the fasteners that hold the power supply or fan unit in place.

Step 5 Pull the unit from the bay.

154012

Power Supply

LEDs

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 77 78

Pas de commentaire

Cisco Systems SFS 7000P Manuel d'installation Page 52