Cisco Systems SFS 7000P Manuel d'installation télécharger pdf (Page 64)

Chapter 5 Hardware Diagnostic Tests

Running Card Tests

5-2

Cisco SFS 7000P Hardware Installation Guide

OL-9167-01 Rev. A0

Self-Tests

The Cisco SFS 7000P switch provides the following diagnostic tests:

• Card Self-Test

• Fan Self-Test

• Power Supply Self-Test

Running Card Tests

The term “cards” in this section refers to fabric controllers, management I/O

modules, node cards, and the chassis ID module. Fans and power supplies are not

included in the card tests; they can be tested through the standard chassis test or

as individual components.

The following tests are available to locate and diagnose one or more cards in the

chassis:

• LED

• Self-test

Running a Card Self-Test

To perform a diagnostic self-test on a card, follow these steps:

Step 1 Enter the diag card number command.

SFS-7000P> enable

SFS-7000P# config

SFS-7000P(config)# diag card 11

SFS-7000P(config-diag-card-11)# test self-test

SFS-7000P(config-diag-card-11)# start

SFS-7000P(config-diag-card-11)# exit

SFS-7000P(config)# exit

Note You can stop the diagnostic self-test at any time by entering the stop command.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 77 78

Pas de commentaire

Cisco Systems SFS 7000P Manuel d'installation Page 64