Cisco Systems ONS 15310-CL Guide de dépannage Page 177

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 334
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 176
2-67
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 2 Alarm Troubleshooting
2.7.97 FSTSYNC
2.7.97 FSTSYNC
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Object: NE-SREF
A Fast Start Synchronization Mode condition occurs when the ONS 15310-CL or ONS 15310-MA is
choosing a new timing reference. The previous timing reference has failed.
The FSTSYNC condition disappears after approximately 30 seconds. If the condition does not clear, log
into the Technical Support Website at http://www.cisco.com/techsupport for more information or call
Cisco TAC (1-800-553-2447).
Note FSTSYNC is an informational condition. It does not require troubleshooting.
2.7.98 FULLPASSTHR-BI
The FULLPASSTHR-BI condition is not used in the ONS 15310 platforms in this release. It is reserved
for development.
2.7.99 GFP-CSF
Default Severity: Major (MJ), Service-Affecting (SA)
SONET Logical Object: CE100T
The GFP Client Signal Fail Detected alarm is a secondary alarm raised on local GFP data ports when a
remote Service-Affecting (SA) alarm causes invalid data transmission. The alarm is raised locally on
ML-100T-8 Ethernet ports and does not indicate that a Service-Affecting (SA) failure is occurring at the
local site, but that a CARLOSS, LOS, or SYNCLOSS alarm is affecting a remote data port’s
transmission capability. For more information about Ethernet cards, refer to the Cisco ONS 15310-CL
and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration Guide.
Clear the GFP-CSF Alarm
Step 1 Clear the Service-Affecting (SA) alarm at the remote data port.
Step 2 If the GFP-CSF alarm does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447) to report
a Service-Affecting (SA) problem.
2.7.100 GFP-EX-MISMATCH
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: CE100T
Vue de la page 176
1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 333 334

Commentaires sur ces manuels

Pas de commentaire