Cisco Systems OL-9977-05 Manuel d'utilisateur télécharger pdf (Page 27)

1-7

Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide

OL-9977-05

Chapter 1 Overview

Network Configuration Examples

Wireless Backhaul

The access point supports wireless backhaul capability using the 5-GHz radio to bridge to another access

point to reach a wired network connection to a controller (see

Figure 1-2). The access point connected

to the wired network is considered a RAP in this configuration. The remote access point is considered a

MAP and transfers wireless client traffic to the RAP for transfer to the wired network. Lightweight

access point protocol (LWAPP) control traffic is also transferred over this bridged link.

Note The LAP 1505 model uses the 2.4-GHz radio for backhaul and wireless client operations.

Figure 1-2 Access Point Backhaul Example

Point-to-Point Bridging

The access points can be used to extend a remote network by using the 5-GHz backhaul radio to bridge

the two network segments as shown in

Figure 1-3. To support Ethernet bridging, you must enable

bridging on the controller for each access point.

Note The LAP 1505 model uses the 2.4-GHz radio for bridging operations.

Wireless client access is supported; however, if bridging between tall buildings, the 2.4-Ghz wireless

coverage area may be limited and possibly not suitable for direct wireless client access.

Figure 1-3 Access Point Point-to-Point Bridging Example

148438

(5.8 Ghz)

(2.4 Ghz)

148440

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 87 88

Pas de commentaire

Cisco Systems OL-9977-05 Manuel d'utilisateur Page 27