Cisco Systems SPA2102 Guide de l'utilisateur télécharger pdf (Page 21)

Phone Adapter with Router

Chapter 4: Getting Started

Placing the Phone Adapter

There are two ways to place the Phone Adapter. The first way is to place the Phone Adapter horizontally on a

surface. The second way is to mount the Phone Adapter on a wall. The wall-mount option is explained in further

detail below.

Wall-Mount Option

The Phone Adapter has two wall-mount slots on its back panel. The distance between the two slots is 58 mm

(2.28 inches).

1. Determine where you want to mount the Phone Adapter.

2. Drill two holes into the wall. Make sure the holes are 58 mm (2.28 inches) apart.

3. Insert a screw into each hole, and leave 5 mm (0.2 inches) of its head exposed.

4. Maneuver the Phone Adapter so the wall-mount slots line up with the two screws.

5. Place the wall-mount slots over the screws and slide the Phone Adapter down until the screws fit snugly into

the wall-mount slots.

Congratulations! The installation of the Phone Adapter is complete.

Figure 4-10: Measurement between

Wall-Mount Slots

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 95 96

Pas de commentaire

Cisco Systems SPA2102 Guide de l'utilisateur Page 21