Cisco Systems SPA2102 Guide de l'utilisateur télécharger pdf (Page 38)

Phone Adapter with Router

Chapter 6: Using the Web-based Utility

The Router Tab

The Router - LAN Setup Screen

This screen lets you configure the local network, dynamic DHCP, and static DHCP lease settings.

Networking Service. Select the service you want to use, NAT or Bridge. The default is NAT.

LAN Network Settings

LAN IP Address. Enter the local IP address of the Phone Adapter. The default is 192.168.0.1.

LAN Subnet Mask. Select the local subnet mask: 255.255.255.0, 255.255.255.128, 255.255.255.192,

255.255.255.224, 255.255.255.240, 255.255.255.248, or 255.255.255.252. The default is

255.255.255.0.

Enable DHCP Server. To use the Phone Adapter as a router assigning IP addresses, select yes. Otherwise, select

no. The default is yes.

DHCP Lease Time. Enter the lease time used by the Phone Adapter to distribute IP addresses. The default is 24

Hours.

DHCP Client Starting IP Address. When the Phone Adapter issues IP addresses, it starts with the first value of

its DHCP client IP address range. Enter that value here. The default is 192.168.0.2.

Number of Client IP Addresses. Enter the number of IP addresses that can be distributed. The default is 50.

Static DHCP Lease Settings

Enable. You can have the Phone Adapter assign the same IP address to a specific device. To disable this feature,

select no. To use this feature, select yes. The default is no.

Figure 6-6: Router - LAN Setup Screen

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 95 96

Pas de commentaire

Cisco Systems SPA2102 Guide de l'utilisateur Page 38