Cisco Systems XR 12410 Manuel d'installation télécharger pdf (Page 105)

3-29

Cisco XR 12410 Router Installation Guide

OL-13832-01

Chapter 3 Installing the Cisco XR 12410 Router

Reinstalling Components After Installing the Chassis

Reinstalling DC PEMs

Use the following procedure to reinstall the DC PEMs back into the chassis.

Step 1 Install the DC PEM (Figure 3-21):

a. Slowly push the power supply into the chassis until it mates with the

backplane connector at the back of the bay.

Caution To prevent damage to the power shelf backplane connector, do not use excessive

force when inserting a power supply into the chassis.

b. Lift the ejector lever into place and tighten the captive screw to securely seat

the power supply to the backplane connector.

Figure 3-21 Installing a DC PEM

Step 2 Repeat Step 1 for the other power supply.

Step 3 Go to the “Reinstalling the Blower Module” section on page 3-30 to install the

blower module.

129276

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 229 230

Pas de commentaire

Cisco Systems XR 12410 Manuel d'installation Page 105