Cisco Systems XR 12410 Manuel d'installation télécharger pdf (Page 106)

Chapter 3 Installing the Cisco XR 12410 Router

Reinstalling Components After Installing the Chassis

3-30

Cisco XR 12410 Router Installation Guide

OL-13832-01

Reinstalling the Blower Module

Use the following procedure to reinstall the blower module in the chassis.

Step 1 Install the blower module into the chassis (Figure 3-22):

a. Lift the blower module (with two hands) and slide it halfway into the module

bay.

b. Slowly push the blower module into the chassis until it mates with the

backplane connector at the back of the module bay.

Caution To prevent damage to the connectors, do not use excessive force when inserting

the blower module into the chassis.

c. Tighten the captive screws on the blower module to secure it to the chassis.

Figure 3-22 Installing the Blower Module

122100

DOWN

LOOP RA LA

CDHNT CD

DOWN

LOOP RA LA

CDHNT CD

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 229 230

Pas de commentaire

Cisco Systems XR 12410 Manuel d'installation Page 106