Cisco Systems XR 12410 Manuel d'installation Page 174

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 230
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 173
Chapter 5 Maintaining the Router
Removing and Replacing the Blower Module
5-10
Cisco XR 12410 Router Installation Guide
OL-13832-01
Step 2 Install the new blower module into the chassis (Figure 5-6):
a. Lift the blower module (with two hands) and slide it halfway into the module
bay.
b. Slowly push the blower module into the chassis until it mates with the
backplane connector at the back of the module bay.
Caution To prevent damage to the connectors, do not use excessive force when inserting
the blower module into the chassis.
c. Tighten the captive screws on the blower module to secure it to the chassis.
The (green) OK status indicator on the front of the blower module goes on. If
the OK indicator does not light, see the
“Troubleshooting the Blower Module
Installation” section on page 5-11.
Figure 5-6 Installing the Blower Module
122100
A
C
T
0
DOWN
LOOP RA LA
CDHNT CD
TX
0
RX
TX
1
RX
DOWN
LOOP RA LA
CDHNT CD
TX
0
RX
TX
1
Vue de la page 173
1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 229 230

Commentaires sur ces manuels

Pas de commentaire