Cisco Systems C2960XSTACK Manuel d'utilisateur télécharger pdf (Page 33)

DETAILED STEPS

PurposeCommand or Action

Enters the global configuration mode.configure terminal

Example:

Switch# configure terminal

Step 1

Enables the event agent, and enters the gateway parameters.

cns event {hostname | ip-address}

[port-number] [ [keepalive seconds

Step 2

•

For {hostname | ip-address}, enter either the hostname or the IP address

of the event gateway.

retry-count] [failover-time seconds ]

[reconnect-time time] | backup]

Example:

Switch(config)# cns event

10.180.1.27 keepalive 120 10

•

(Optional) For port number, enter the port number for the event gateway.

The default port number is 11011.

•

(Optional) For keepalive seconds, enter how often the switch sends

keepalive messages. For retry-count, enter the number of unanswered

keepalive messages that the switch sends before the connection is

terminated. The default for each is 0.

•

(Optional) For failover-time seconds, enter how long the switch waits for

the primary gateway route after the route to the backup gateway is

established.

•

(Optional) For reconnect-time time, enter the maximum time interval that

the switch waits before trying to reconnect to the event gateway.

•

(Optional) Enter backup to show that this is the backup gateway. (If

omitted, this is the primary gateway.)

Though visible in the command-line help string, the encrypt and the

clock-timeout time keywords are not supported.

Note

Returns to privileged EXEC mode.end

Example:

Switch(config)# end

Step 3

This example shows how to enable the CNS event agent, set the IP address gateway to 10.180.1.27, set 120

seconds as the keepalive interval, and set 10 as the retry count.

Switch(config)# cns event 10.180.1.27 keepalive 120 10

What to Do Next

To verify information about the event agent, use the show cns event connections command in privileged

EXEC mode.

To disable the CNS event agent, use the no cns event { ip-address | hostname } global configuration command.

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29044-01 21

Configuring Cisco IOS Configuration Engine

Enabling the CNS Event Agent

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 111 112

Commentaires sur ces manuels

Pas de commentaire

Cisco Systems C2960XSTACK Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cisco Systems C2960XSTACK