Cisco Systems C2960XSTACK Manuel d'utilisateur télécharger pdf (Page 40)

This example shows how to configure an initial configuration on a remote switch when the switch IP address

is known. The Configuration Engine IP address is 172.28.129.22.

Switch(config)# cns template connect template-dhcp

Switch(config-tmpl-conn)# cli ip address dhcp

Switch(config-tmpl-conn)# exit

Switch(config)# cns template connect ip-route

Switch(config-tmpl-conn)# cli ip route 0.0.0.0 0.0.0.0 ${next-hop}

Switch(config-tmpl-conn)# exit

Switch(config)# cns connect dhcp

Switch(config-cns-conn)# discover interface gigabitethernet

Switch(config-cns-conn)# template template-dhcp

Switch(config-cns-conn)# template ip-route

Switch(config-cns-conn)# exit

Switch(config)# hostname RemoteSwitch

RemoteSwitch(config)# ip route 172.28.129.22 255.255.255.255 11.11.11.1

RemoteSwitch(config)# cns id ethernet 0 ipaddress

RemoteSwitch(config)# cns config initial 172.28.129.22 no-persist

What to Do Next

To verify information about the configuration agent, use the show cns config connections command in

privileged EXEC mode.

To disable the CNS Cisco IOS agent, use the no cns config initial { ip-address | hostname } global configuration

command.

Refreshing DeviceIDs

Beginning in privileged EXEC mode, follow these steps to refresh a DeviceID when changing the hostname

on the switch.

SUMMARY STEPS

show cns config connections

Make sure that the CNS event agent is properly connected to the event gateway.

show cns event connections

Record from the output of Step 3 the information for the currently connected connection listed below.

You will be using the IP address and port number in subsequent steps of these instructions.

configure terminal

no cns event ip-address port-number

cns event ip-address port-number

end

Make sure that you have reestablished the connection between the switch and the event connection by

examining the output from show cns event connections.

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

28 OL-29044-01

Configuring Cisco IOS Configuration Engine

Refreshing DeviceIDs

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 111 112

Pas de commentaire

Cisco Systems C2960XSTACK Manuel d'utilisateur Page 40