Cisco Systems C2960XSTACK Manuel d'utilisateur télécharger pdf (Page 103)

PurposeCommand or Action

•

(Optional) [, | -] Specifies a series or range of interfaces. Enter a space

before and after the comma; enter a space before and after the hyphen.

•

Enter ingress with additional keywords to enable forwarding of incoming

traffic on the destination port and to specify the encapsulation type:

◦

dot1q vlan vlan-id—Forwards incoming packets with IEEE 802.1Q

encapsulation with the specified VLAN as the default VLAN.

◦ isl—Forwards ingress packets with ISL encapsulation.

◦

untagged vlan vlan-id or vlan vlan-id—Forwards incoming

packets with untagged encapsulation type with the specified VLAN

as the default VLAN.

Returns to privileged EXEC mode.end

Example:

Switch(config)# end

Step 5

Configuring an FSPAN Session

Beginning in privileged EXEC mode, follow these steps to create a SPAN session, specify the source

(monitored) ports or VLANs and the destination (monitoring) ports, and configure FSPAN for the session.

SUMMARY STEPS

configure terminal

no monitor session {session_number | all | local | remote}

monitor session session_number source {interface interface-id | vlan vlan-id} [, | -] [both | rx | tx]

monitor session session_number destination {interface interface-id [, | -] [encapsulation replicate]}

monitor session session_number filter {ip | ipv6 | mac} access-group {access-list-number | name}

end

DETAILED STEPS

PurposeCommand or Action

Enters global configuration mode.configure terminal

Example:

Switch# configure terminal

Step 1

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29044-01 91

Configuring SPAN and RSPAN

Configuring an FSPAN Session

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 111 112

Pas de commentaire

Cisco Systems C2960XSTACK Manuel d'utilisateur Page 103