Cisco Systems WSC2960X48TDL Manuel d'utilisateur télécharger pdf (Page 28)

When you create an SVI, it does not become active until it is associated with a physical port.Note

SVI Autostate Exclude

The line state of an SVI with multiple ports on a VLAN is in the up state when it meets these conditions:

•

The VLAN exists and is active in the VLAN database on the switch

•

The VLAN interface exists and is not administratively down.

•

At least one Layer 2 (access or trunk) port exists, has a link in the up state on this VLAN, and is in the

spanning-tree forwarding state on the VLAN.

The protocol link state for VLAN interfaces come up when the first switchport belonging to the

corresponding VLAN link comes up and is in STP forwarding state.

Note

The default action, when a VLAN has multiple ports, is that the SVI goes down when all ports in the VLAN

go down. You can use the SVI autostate exclude feature to configure a port so that it is not included in the

SVI line-state up-or-down calculation. For example, if the only active port on the VLAN is a monitoring port,

you might configure autostate exclude on that port so that the VLAN goes down when all other ports go down.

When enabled on a port, autostate exclude applies to all VLANs that are enabled on that port.

The VLAN interface is brought up when one Layer 2 port in the VLAN has had time to converge (transition

from STP listening-learning state to forwarding state). This prevents features such as routing protocols from

using the VLAN interface as if it were fully operational and minimizes other problems, such as routing black

holes.

EtherChannel Port Groups

EtherChannel port groups treat multiple switch ports as one switch port. These port groups act as a single

logical port for high-bandwidth connections between switches or between switches and servers. An

EtherChannel balances the traffic load across the links in the channel. If a link within the EtherChannel fails,

traffic previously carried over the failed link changes to the remaining links. You can group multiple trunk

ports into one logical trunk port or multiple access ports into one logical access port. Most protocols operate

over either single ports or aggregated switch ports and do not recognize the physical ports within the port

group. Exceptions are the DTP, the Cisco Discovery Protocol (CDP), and the Port Aggregation Protocol

(PAgP), which operate only on physical ports.

When you configure an EtherChannel, you create a port-channel logical interface and assign an interface to

the EtherChannel. For Layer 2 interfaces, use the channel-group interface configuration command to

dynamically create the port-channel logical interface. This command binds the physical and logical ports

together.

Power over Ethernet Ports

A PoE-capable switch port automatically supplies power to one of these connected devices if the switch senses

that there is no power on the circuit:

Catalyst 2960-X Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX

16 OL-29034-01

Configuring Interface Characteristics

Interface Types

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 107 108

Pas de commentaire

Cisco Systems WSC2960X48TDL Manuel d'utilisateur Page 28