Cisco Systems WSC2960X48TDL Manuel d'utilisateur télécharger pdf (Page 93)

We recommend that you enable power policing when PoE is enabled on your switch. For example, if policing

is disabled and you set the cutoff-power value by using the power inline auto max 6300 interface configuration

command, the configured maximum power allocation on the PoE port is 6.3 W (6300 mW). The switch

provides power to the connected devices on the port if the device needs up to 6.3 W. If the CDP-power

negotiated value or the IEEE classification value exceeds the configured cutoff value, the switch does not

provide power to the connected device. After the switch turns on power on the PoE port, the switch does not

police the real-time power consumption of the device, and the device can consume more power than the

maximum allocated amount, which could adversely affect the switch and the devices connected to the other

PoE ports.

Because the switch supports internal power supplies and the Cisco Redundant Power System 2300 (also

referred to as the RPS 2300), the total amount of power available for the powered devices varies depending

on the power supply configuration.

•

If a power supply is removed and replaced by a new power supply with less power and the switch does

not have enough power for the powered devices, the switch denies power to the PoE ports in auto mode

in descending order of the port numbers. If the switch still does not have enough power, the switch then

denies power to the PoE ports in static mode in descending order of the port numbers.

•

If the new power supply supports more power than the previous one and the switch now has more power

available, the switch grants power to the PoE ports in static mode in ascending order of the port numbers.

If it still has power available, the switch then grants power to the PoE ports in auto mode in ascending

order of the port numbers.

How to Configure PoE

Configuring a Power Management Mode on a PoE Port

For most situations, the default configuration (auto mode) works well, providing plug-and-play operation. No

further configuration is required. However, perform this task to configure a PoE port for a higher priority, to

make it data only, or to specify a maximum wattage to disallow high-power powered devices on a port.

When you make PoE configuration changes, the port being configured drops power. Depending on the new

configuration, the state of the other PoE ports, and the state of the power budget, the port might not be powered

up again. For example, port 1 is in the auto and on state, and you configure it for static mode. The switch

removes power from port 1, detects the powered device, and repowers the port. If port 1 is in the auto and on

state and you configure it with a maximum wattage of 10 W, the switch removes power from the port and

then redetects the powered device. The switch repowers the port only if the powered device is a class 1, class

2, or a Cisco-only powered device.

SUMMARY STEPS

configure terminal

interface interface-id

power inline {auto [max max-wattage] | never | static [max max-wattage]}

end

show power inline [interface-id | module switch-number]

Catalyst 2960-X Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29034-01 81

Configuring PoE

How to Configure PoE

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 107 108

Commentaires sur ces manuels

Pas de commentaire

Cisco Systems WSC2960X48TDL Manuel d'utilisateur Page 93

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Cisco Systems WSC2960X48TDL