Cisco Systems C2960XSTACK Manuel d'utilisateur télécharger pdf (Page 104)

PurposeCommand or Action

Removes any existing SPAN configuration for the session.

no monitor session {session_number |

all | local | remote}

Step 2

•

For session_number, the range is 1 to 66.

Example:

Switch(config)# no monitor session

• all—Removes all SPAN sessions.

• local—Removes all local sessions.

• remote—Removes all remote SPAN sessions.

Specifies the SPAN session and the source port (monitored port).

monitor session session_number source

{interface interface-id | vlan vlan-id} [,

| -] [both | rx | tx]

Step 3

•

For session_number, the range is 1 to 66.

Example:

Switch(config)# monitor session 2

•

For interface-id, specify the source port or the source VLAN to monitor.

•

For source interface-id, specify the source port to monitor. Only physical

interfaces are valid.

source interface

gigabitethernet1/0/1

•

For vlan-id, specify the source VLAN to monitor. The range is 1 to 4094

(excluding the RSPAN VLAN).

A single session can include multiple sources (ports or VLANs)

defined in a series of commands, but you cannot combine source

ports and source VLANs in one session.

Note

•

(Optional) [, | -] Specifies a series or range of interfaces. Enter a space

before and after the comma; enter a space before and after the hyphen.

•

(Optional) [both | rx | tx] Specifies the direction of traffic to monitor. If

you do not specify a traffic direction, the SPAN monitors both sent and

received traffic.

◦ both—Monitors both sent and received traffic. This is the default.

◦ rx—Monitors received traffic.

◦ tx—Monitors sent traffic.

You can use the monitor session session_number source

command multiple times to configure multiple source ports.

Note

Specifies the SPAN session and the destination port (monitoring port).

monitor session session_number

destination {interface interface-id [, | -]

[encapsulation replicate]}

Step 4

•

For session_number, specify the session number entered in Step 3.

Example:

Switch(config)# monitor session 2

•

For destination, specify the following parameters:

◦

For interface-id, specify the destination port. The destination interface

must be a physical port; it cannot be an EtherChannel, and it cannot

be a VLAN.

destination interface

gigabitethernet1/0/2 encapsulation

replicate

◦

(Optional) [, | -] Specifies a series or range of interfaces. Enter a space

before and after the comma; enter a space before and after the hyphen.

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

92 OL-29044-01

Configuring SPAN and RSPAN

Configuring an FSPAN Session

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 110 111 112

Commentaires sur ces manuels

Pas de commentaire

Cisco Systems C2960XSTACK Manuel d'utilisateur Page 104

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cisco Systems C2960XSTACK